Performing Feed Adjustment During Printing - Epson SureColor SC-S30600 User Manual

SC-S30600 Series User's Guide
G
Select Primary and press the Z button.
H
Use the d/u buttons to select a test pattern and
press the Z button twice.
The longer the pattern, the more accurate the
adjustment.
I
The printer will print a test pattern.
When printing is complete, the media will
automatically be fed to a position where the
pattern is clearly visible.
Note:
To rewind the media, press the u button.
J
Measure the distance between the "+" symbols.
Record either the distance between the two
center symbols or the average of the distances
between the left, center, and right symbols.
K
Pattern length is displayed in the control panel.
Using the d/u buttons, enter the value recorded
in Step 10 and press the Z button.
Secondary Adjustment
L
Perform Steps 1 to 6.
M
Use the d/u buttons to select Secondary and
press the Z button twice.
N
The printer will print a test pattern.
When printing is complete, the media will
automatically be fed to a position where the
pattern is clearly visible.
Cut the media if necessary.
Basic Operations
"Cutting Media" on page 34
U
Note:
To rewind the media, press the u button.
O
Check the pattern and note the pattern number
with the lightest colors.
In the following example, this would be pattern
number 3.
A
P
The pattern number is displayed in the control
panel. Using the d/u buttons, enter the pattern
number recorded in Step 14 and press the Z
button.
Q
Enter the number for each line, from A to F, and
press the Z button.
R
The menus will close after you enter the pattern
number for the last line.
Performing Feed Adjustment
During Printing
Buttons that are used in the following settings
48
1 2 3 4 5