Epson SureColor SC-S30600 User Manual page 75

SC-S30600 Series User's Guide
RIP Settings
Item
Platen Gap
Head Alignment
Input thickness.
Auto(Uni-D)
Auto(Bi-D)
Manual(Uni-D)
Manual(Bi-D)
Roll Type
Tension Measurement
Media Tension
1 to 30 (media setting bank number)
Item
Setting Name
Using the Control Panel Menu
Parameter Explanation
1.5 Change Platen Gap (the gap between the print head and the media) for
the media setting bank selected in the software RIP.
2.0
The default setting of 1.5 is recommended in most situations. Choose 2.0 if
printout is scratched or smudged.Select 2.5 only if print results are still
2.5
smudged when 2.0 is selected. Choosing a larger gap than required may
result in ink stains inside the printer, reduced print quality, or shorter
product life.
0.1 to 1.0 mm (4 to Enter a value for media thickness of from 0.1 to 1.0 mm (4 to 60 mil).
40 mil)
Print Select Head Alignment to align print head when print results seem grainy
or out of focus. Auto adjustment aligns the head automatically using data
collected by a sensor while a test pattern is printed. U
on page 43
In manual adjustment, you need to check the pattern and enter the
optimum adjustment value for alignment. U
Misalignment (Head Alignment)" on page 46
Printable Side Out Choose Printable Side Out or Printable Side In according to how the
media is rolled.
Printable Side In
Periodically Choose Periodically or Every page to have the printer automatically
monitor and adjust media tension during printing for optimal results, Off
Every page
to disable automatic tension adjustment. Periodically is recommended
in most circumstances. The printer may however be unable to adjust
Off
tension appropriately for some media, resulting in excessive slack or other
maladjustments that cause printing problems, in which case you should
select Off. Note, however, that Off may result in unusually large margin
between pages. In addition, printing may not stop and the inside of the
printer may become stained. Observe the following precautions:
❏
Do not print at the end of a roll
❏
Do not select Off for Media End Check.
Select Every page for more precise tensioning, but note that print times
will increase.
0 to 40 Increase tension if creases appear in media during printing. The higher the
value, the greater the tension.
Parameter Explanation
Assign the media setting bank a name up to 22 half-size characters long.
Using distinctive names makes it easier to select banks for use.
75
"Head Alignment"
"Correcting Print