Printable Area - Epson SureColor SC-S30600 User Manual

SC-S30600 Series User's Guide
A
Press the button during printing.
B
An adjustment value will be displayed. /Use the
d/u buttons to select a value.
If the feed amount is too small, black bands (dark
stripes) will appear; adjust the feed amount
upwards.
If, in contrast, the feed amount is too large, white
bands (pale stripes) will appear; adjust the feed
amount downwards.
C
If you are not satisfied with the results, use the
d/u buttons to enter an adjustment value.
D
Press the Z button when settings are complete.
Once the feed amount has been adjusted,
printing will continue at the new value.
Note:
The new value is erased when:
❏ The media loading lever is raised
❏ The printer is turned off
❏ Changes are made to Feed Adjustment in the
Media Setup menu.

Printable area

The gray area in the illustration below shows the
printable area. The arrow indicates the feed direction.
A
The positions of items
A
(right edge of media)
Varies with the option selected for Media Size
Check.
On selected for Media Size Check: The right edge of
the media.
Off selected for Media Size Check: The default right
edge position (as far as the platen past the center of
the label on the pre-heater).
B
(left edge of media)
Basic Operations
B
to are as follows:
Varies with the option selected for Media Size
Check.
On selected for Media Size Check: The left edge of
the media.
Off selected for Media Size Check: 64 inches from
the default right edge.
1
3-25mm*
B
*1 The value selected for Side Margin(Left) in the setup menu.
The default value is 5 mm.
Choose a Side Margin(Left) over 10 mm when using media
holding plates.
*2 The total of the values selected for Print Start Position and
Side Margin(Right) in the setup menu. The default value is 5
mm.
Choose a Print Start Position or Side Margin(Right) over 10
mm when using media holding plates.
Note:
The options selected for Side Margin and Print Start
Position have no effect on the printable area.
49
300-1626mm
3-825mm*
5mm
5mm
2
A