Handling Media - Epson SureColor SC-S30600 User Manual

SC-S30600 Series User's Guide
❏ Use a cleaning stick from the supplied maintenance
kit to wipe ink from the ink supply port of cartridges
that have been removed from the printer before all
the ink is used. Dried ink on the supply port may
cause ink leaks when the cartridge is reinserted and
used.
While cartridges are in storage, keep the ink supply
ports free of dust. The ink supply port has a valve in
it so it does not need to be capped.
❏ Removed ink cartridges may have ink around the
ink supply port, so be careful not to get any ink on
the surrounding area when removing the
cartridges.
❏ To maintain the quality of the print head, this
printer stops printing before ink cartridges are
completely expended.
❏ Although the ink cartridges may contain recycled
materials, this does not effect printer function or
performance.
❏ Do not dismantle or remodel ink cartridges. You
may not be able to print properly.
❏ Do not drop or knock it against hard
objects;otherwise, the ink may leak.
❏ Ink cartridges inserted in the printer should be
removed and shaken thoroughly about once every
three weeks.
Shaking ink cartridges U
page 67

Handling Media

Note the following when handling or storing media.
Media that are in poor condition will not produce good
quality prints.
Introduction
"How to replace" on
18
Be sure to read the documentation provided with each
type of media.
Notes on Handling
❏ Do not fold the media or damage the printable
surface.
❏ Do not touch the printable surface. Moisture and
oils from your hands can affect print quality.
❏ When handling media, hold it by both edges. We
recommend wearing cotton gloves.
❏ Keep the media dry.
❏ Packaging materials can be used to store media and
should not be thrown away.
❏ Avoid locations that are subject to direct sunlight,
excessive heat, or humidity.
❏ When not in use, media should be removed from
the printer, rewound, and inserted in its original
packaging for storage. Leaving media in the printer
for extended periods may cause it to deteriorate.
Handling Media After Printing
To maintain long lasting, high quality print results, note
the following points.
❏ Do not rub or scratch the printed surface. If they are
rubbed or scratched, the ink may peel off.
❏ Do not touch the printed surface, as this may
remove the ink.
❏ Make sure printouts are completely dry before
folding or stacking, as otherwise discoloration or
other marks may appear where the prints touch.
These marks will disappear if the prints are
immediately separated and dried but will become
permanent if the surfaces are not separated.
❏ Avoid direct sunlight.
❏ To prevent discoloration, display and store prints as
instructed in the documentation supplied with the
media.