Feed Adjustment (Manual Feed Adjustment); Using A Test Pattern - Epson SureColor SC-S30600 User Manual

SC-S30600 Series User's Guide
I
When C1 is displayed in the control panel, use
the d/u buttons to select the number recorded in
Step 8 and press the Z button.
J
Select a pattern number for each color, from C1
to BK2, and press the Z button.
K
The media setup menu will be displayed when
you enter the pattern number for the last color.
Feed Adjustment (Manual
Feed Adjustment)
Feed Adjustment is used to correct banding (horizontal
banding, lines, or strips of uneven color).
Feed Adjustment can be performed automatically or
manually.
For more information on automatic feed adjustment,
see U "Feed Adjustment" on page
This section explains how to perform manual feed
adjustment.
Two methods are available:
❏ Visually inspect print results and enter a correction
by hand.
❏ Enter a correction during printing and inspect the
results.
Note:
Feed Adjustment varies with the media used. Load the
media for which feed adjustment is required under the
same conditions as the actual print job. For example, if
you are using the auto take-up reel unit for printing, the
auto take-up reel unit should also be used for feed
adjustment.
Furthermore, when installing the heavy roll media
system, the media must be loaded and feed adjustment
performed again, even if once you adjust with the
standard roll media system.
Adjust the feed manually if you feel that auto feed
adjustment has not completely resolved the problem.
Basic Operations

Using a Test Pattern

Primary and Secondary adjustments are required.
Normally the Secondary adjustment is performed after
the Primary adjustment. Primary adjustment alone
may be sufficient if you only wish to accurately print the
length of a design.
Buttons that are used in the following settings
42.
A
B
C
D
E
F
Primary Adjustment
47
After confirming that the printer is ready to
print, press the Menu button.
The settings menu will be displayed.
Select Media Setup and press the Z button.
Use the d/u buttons to select Customize
Settings and press the Z button.
Use the d/u buttons to select a media setting
bank number between 1 and 30 and then press
the Z button.
Note that any settings already saved in the printer
will be overwritten.
Use the d/u buttons to select Feed Adjustment
and press the Z button.
Select Manual and press the Z button.