Replacing The Display Face With Keypad; Procedure - Precor Energy Series Service Manual

Replacing the Display Face with Keypad.

Note: The keypad is furnished as part of the display face, the display face must be replaced when a
replacement keypad is required.

Procedure

1. Set the treadmill on/off switch in the "off" position and remove the treadmill power cord from
the AC outlet.
2. A grounded anti-static wrist strap must be worn whenever the upper PCA is being handled.
3. Remove the four screws that fasten the backplate to the rear of the console and remove the
console from the backplate.
4. Disconnect the data cable and heart rate cable (if included) from the console
5. Remove the six screws that fasten the display face to the console rear cover...
6. Disconnect the JK6 keypad connector, the JK7 safety switch connector and the JK10 user 1/2
keypad connector from the upper PCA.
7. Remove the two screws that fasten the safety switch to the display face and remove the safety
switch.
8. Remove the four screws that fasten the upper PCA to the display face and remove the upper
PCA from the display face.
9. Install the safety switch in its mounting position on the replacement display face and fasten
with attachment hardware.
10. Install the upper PCA in its mounting position in the replacement display face and fasten with
attachment hardware. Connect the keypad cable to the JK6 connector, safety switch cable to
the JK7 connector and the user 1/2 keypad cable to the JK10 connector of the upper PCA.
11. Install the console rear cover in its mounting position on the display face and tighten the six
attachment screws.
12. Connect the data cable to the JK8 connector on the console and the heart rate cable to the
JK5 connector on the console.
13. Install the console in its mounting position on the backplate and tighten the six attachment
screws.
14. Verify the treadmill operation.
©2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page
Page 42
of 5442
Page 42