Operation Verification Check; Procedure - Precor Energy Series Service Manual

Operation Verification Check

This section provides an operational check of the treadmill basic functionality. Use this procedure
to verify the treadmill operation at the completion of a maintenance procedure or any time it is
necessary to ensure that the treadmill is operating properly. For a complete guide to all operating
functions, refer to the Operators Manual.

Procedure

1. Plug the power cord into the AC outlet. Set the safety switch to the operating position on the
console. Set the ON/OFF switch in the "ON" position, the ON/OFF switch should illuminate. All
of the LED's on the display should illuminate for a couple of seconds and the scroll the
message PRESS QUICKSTART OR
lower PCA.
2. Place the treadmill in Manual Mode. Adjust the speed of the running belt to 2–3 mph
11. Remove the safety switch from the console. The display should go blank and the treadmill belt
stop. Replace the safety switch on the console, all of the LED's on the display should
illuminate for a couple of seconds and the scroll the message
3. Place the treadmill in Manual Mode. Adjust the speed of the running belt to 2–3 mph
12. Operate the treadmill for at least 5 minutes.
a. Concentrate on the feel of the running belt and the sound of the drive motor and rollers. Be on
the alert for unusual noises, smells, or vibrations.
b. Log the AC input current under loaded and unloaded conditions.
c. Observe the LED's on the electronic console. Make sure that each LED lights as the in-
formation corresponding to that LED is displayed on the electronic console.
4. Press the STOP key. When the treadmill comes to a stop, view the electronic console as the
treadmill the message
display. Adjust the speed of the running belt to 2–3 mph
5. Press the INCLINE
bed inclines and the incline display increments to 15% as the INCLINE
6. Press the INCLINE
bed re turns to a level position and the incline display decrements to 0% as the INCLINE
down key is pressed.
7. Set the ON/OFF switch in the "OFF" position, then unplug the treadmill from the AC outlet.
© 2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
PROGRAM. The POWER LED will illuminate on the
PAUSED - PRESS QUICK START TO CONTINUE
up key while viewing the electronic console. Confirm that the running
down key while viewing the electronic console. Confirm that the running
PRESS QUICKSTART OR
scrolls on the
up key is pressed.
11Page 11 of 54