Table of Contents
Advertisement
I
CHANGE: In Manual mode, the CHANGE key lets you select the feature that you want to appear on
the display. The feature remains displayed until you press CHANGE again. In other programs,
pressing the CHANGE key activates the scan function. Starting from the top of the display, each
feature is displayed sequentially and then, the course profile reappears. Note that HEART RATE
only appears if you are using the Precor Heart Rate Option.
Customizing the Display
The M9.41si treadmill displays U,S. Standard units of measure: miles per hour (mph) and miles, or
the Metric Standard; kilometers per hour (kph) and kilometers. You can also change whether the
TIME or DISTANCE prompt appears after you choose a preprogrammed course and set the
scrolling speed for messages on the display. To change these settings, take the following steps;
Note: The M9.41si treadmill will retain your selection even when it is turned OFF and unplugged.
You can change your selection at any time by repeating the following steps.
1.
Insert the magnetic safety key into the electronic console.
2.
Turn ON the treadmill using the power switch located at the front of the hood.
3.
At the Precor banner, press the STOP key, followed immediately by the QUICK START key,
then the SPEED ▼ key, and lastly the SPEED A key. (The numbers 5,6 appear sequentially on
the display.) The prompt, "PRESS
A
FOR MPH OR
T
FOR KPH" appears on the display.
Important: If the QUICK START key is not pressed within 1 second after pressing the STOP
key, you will need to press the STOP key again after the message "Bell Starting 3,2,1"
scrolls across the display.
4.
Press the appropriate
T
or
A
key.
5.
Two messages scroll across the display: one confirms your mph or kph selection and the
other states, "PUSH
A
FOR DISTANCE OR
T
FOR TIME OR 'RESET' TO ASK." Press the
appropriate key after answering one of the following if/then scenarios:
Note: When using a preprogrammed course, you can measure your workout by distance or
time. You see the "SELECT DISTANCE" or "SELECT TIME" prompt after you enter a course
selection. The default measurement is distance.
I
Ifyouwant,...
Then,...
_
your workout measured by distance
press the
A
key
your workout measured by time
press the T key
the option of selecting time or
distance prior to each workout
press HOLD TO RESET (STOP)
After you press an arrow key, a message scrolls across the display
confi rmi ng you r selection.
6.
A prompt "SET SCROLLING. SPEED" appears on the display. Any
T
or
A
key lets you change
how fast a message scrolls across the display. Slow the scrolling by choosing a lower
number. Numbered choices are from 1 to 32.
7.
The changes have been retained in the treadmill's memory. Continue with your workout or
turn OFF the treadmill. If you turn OFF the treadmill, be sure to store the safety key in a safe
place to prevent unauthorized use.
page 12
Advertisement
Table of Contents
