Media Wrinkles Or Shrinks; Is The Media Loaded And Set Up Straight And Securely; Was Loaded Media Allowed To Stand For Some Time; Was The Media Loaded While The Heater Was Hot - Roland VersaSTUDIO User Manual

Media Wrinkles or Shrinks

Is the media loaded and set up straight and securely?

Feed is not smooth when the media is not straight or is tensioned unevenly on the left and right. Reload
the media.
RELATED LINKS
・
P. 20Loading Media

Was loaded media allowed to stand for some time?

Media may shrink or wrinkle if it is heated for an extended time. When printing ends, press and hold down
the [POWER] key to switch off the sub power or remove the media.

Was the media loaded while the heater was hot?

Loading media after the heater has warmed up causes the temperature of the media to rise suddenly,
which may cause the media to shrink or wrinkle during printing. Before loading media, switch off the sub
power and allow the platen to cool.

Is the temperature of room too low?

Use this machine in an environment having an ambient temperature of 20 to 32°C (68 to 90°F). If the ma-
chine is used at an ambient temperature less than 20°C, then depending on the type or width of the me-
dia, wrinkling or temperature-caused unevenness may occur. To obtain stable printing results, the machine
should be used at an ambient temperature of 20 to 32°C (68 to 90°F).

Is the humidity of the room too high?

Use this machine in the environment of 35 to 80 %RH (non condensation).

Is the using media deflected?

If using the deflected media, it cause winkle of the media.
95
Media Feed Problems