Bay Networks Remote Annex User Manual page 43

• Criteria includes the conditions for the filter. This section
uses a keyword followed by a value. You can enter:
•
dst_address
followed by an IP address.
• (the destination port) followed by a port
dst_port
number from 1-65535 or by a service name.
• (the source port number) followed by a port
src_port
number from 1-65535 or by a service name.
•
src_address
an IP address.
•
address_pair
between two addresses, followed by two IP addresses.
You must enter both addresses, separated by a space, on
the same line. If you use this keyword, you cannot use
dst_address
• for incoming or outgoing packets passing
port_pair
between two ports or services, followed by a port number
or service name. If you use this keyword, you cannot use
or
dst_port src_port
• (the packet's transport protocol) followed by
protocol
a number from 1 to 65535 or by
To match all addresses or port numbers, enter -
in place of an address or port number. For service
names, you can enter
,
nfs nntp
rtelnet
or
login
these service names, refer to the Remote Annex
Administrator's Guide for UNIX.
Remote Annex Server Tools for Windows NT
Chapter 3
(the packet's destination address)
(the packet's source address) followed by
for incoming or outgoing packets passing
or .
src_address
.
tcp
,
domain
, , ,
rlogin route routed
, , ,
sftp smtp telnet
. For the port numbers that correspond to
®
User Guide
Understanding Erpcd
, , or .
udp icmp
or
1 *
, , ,
finger ftp name
, ,
router
, , ,
tftp, time who
3-11