Nortel VoIP Gateway Configuration Manual page 108

108 Using VoIP Gateway features
Table 17 Using the VoIP Gateway features (Continued)
Feature Parameter
Use "Fast IsFastConnectUsed
Connect"
Note: Fast start and Tunneling can be used together.
procedure
Use IsTunnelingEnabled
"Tunneling"
procedure
Default DefaultNumber
number
This is used to get call setups from end-points that do not send called phone
number.
Automatic IsDialNeeded
dialing
TargetOfChannel
This is used to perform automatic dialing once OFF HOOK or ringing is detected.
There is no need to dial in this mode.
For each channel, define destination phone number, using
"TargetOfChannel<channel> = phone number" definition.
Choose Coder CoderName
Several Coders CoderName
In this mode, several codecs are sent in the capabilities message. After
negotiation with the remote side a single coder will be selected for transmitting
and receiving messages.
Annex D Fax IsFaxUsed
To use Annex D Fax, configure:
UseT38orFRF11 = 1 (T.38)
FaxTransportMode =1 (relay)
To improve Fax transmission over congested IP network, use optional
redundancy parameters:
FaxRelayEnhancedRedundancyDepth = N
FaxRelayRedundancyDepth =M
N = 0 to 4
M = 0 to 2
Using out of IsDTMFUsed
band DTMF DTMFTransportType
signaling over DTMFDetectionPoint
H.245 and Is931MsgUsed
HookFlash IsHookFlashUsed
signaling OpenH245onFS
When using H.245 out of band signaling, disable inband signaling (mute and
don't relay the digits). In addition, disable the Q.931 sending.
Using "DTMFVolume = " set the level of played DTMF digits.
Note: When using Fast Start the H.245 channel remains closed, and out of band
signaling can not be used, unless "OpenH245onFS" is set to 1 or the remote
gateway/terminal opens the H.245 channel.
P0606298 02
Value
1
1
Default number
0
Phone numbers
to dial
Preferred coder
name
List of coders
1
ports
1
0
0
0
1
1