Upgrading To Bcm 4.0 And Srg 1.5; Upgrading The Bcm400 Expansion Gateway - Nortel BCM 4.0 Upgrade Manual

Chapter 3
Post-upgrade activities
The following section contains a list of activities that must be performed after running the Upgrade
Wizard.
Note: You may not need to do all of these activities. Not all systems use all the
functions listed below.
You must manually configure the items that were not preserved from BCM 3.6/3.7.
The post-upgrade activities are divided into three parts:
• "BCM system tasks" on page 19
• "Installing Reporting for Contact Center (RCC)" on page 23
• "Client upgrade tasks" on page 22
Many of these tasks require Element Manager. You can refer to the BCM 4.0 Installation Checklist
and Quick Start Guide for basic Element Manger information, and the BCM 4.0 Administration
Guide for more detailed information about Element Manager.
BCM system tasks
Perform the following tasks dealing with your BCM 4.0 system after running the Upgrade Wizard:
• Download and install Element Manager: Open a web browser and access the BCM 4.0
system web page. Download and install Element Manager on the management computer.
Refer to the BCM 4.0 Installation Checklist and Quick Start Guide for more information on
obtaining and installing Element Manager.
• Connect to your BCM 4.0 system using Element Manager: Use the default username and
password, nnadmin and PlsChgMe!, to access your BCM 4.0 system using Element
Manager. The first time you connect to the system, you must change your password before
continuing (After you enter the new password, click the Welcome link to activate the confirm
password box). Refer to the BCM 4.0 Installation Checklist and Quick Start Guide for more
information on obtaining Element Manager and connecting to the system.
• Connect the UPS to your system: If your BCM system requires a UPS service for graceful
shutdown, do the following to reconnect the UPS:
1
Re-connect your BCM system to the UPS using a USB cable and the USB port on your
system.
2 In Element Manager enable the UPS on your system (Administration > System Status >
UPS Status).
• Change the default password: For added security, you can change the default password for
your nnadmin account and associated telset ID.
19
Upgrade Guide