Cn-3934 Board - Sony PWS-110RX1A Service Manual

5-21.

CN-3934 Board

Preparation
1. Remove the top panel assembly. (Refer to
2. Remove the fan duct (110). (Refer to
3. Remove the CN-3698 board. (Refer to
4. Remove the RC holder assembly. (Refer to
5. Remove the iAP-005 board assembly. (Refer to
Procedure
1. Disconnect the two connectors with lead wires from the connectors (CN002, CN003) on the CN-3934 board.
Note
When disconnecting the connector with lead wire, pull out the connector part with your fingers.
2. Remove the CN-3934 board in the direction of the arrow.
3. Install the removed parts by reversing the steps of removal.
PWS-110RX1A
"5-4. Top Panel Assembly".)
"5-12. Fan Assembly".)
"5-14. CN-3698 Board".)
"5-11. HPR-48 Board".)
"5-17. iAP-005 Board
Rear of this unit
Assembly".)
Connectors with
lead wires
CN002
CN003
CN-3934 board
5-35