Recovery By Replacing Ssd Module - Sony PWS-110RX1A Service Manual

11. Execute the following command.
Note
The volume number and drive letter of the following command may differ depending on the operating environment.
(1) Copy ReAgent.xml in the label [Windows] to the label [System].
X:\windows\system32>copy C:\Windows\System32\Recovery\ReAgent.xml
F:\Recovery\ReAgent.xml
(2) Execute the diskpart command.
X:\windows\system32>diskpart
(3) Select the label [Windows].
DISKPART>select volume 0
(4) Format the volume of the label [Windows] in ntfs.
DISKPART>format quick fs=ntfs label="Windows"
(5) Exit the diskpart command.
DISKPART>exit
(6) Expand install.wim in the label [Recovery] to the label [Windows].
X:\windows\system32>dism.exe /Apply-image /ImageFile:F:\recovery
\install.wim /Index:1 /ApplyDir:C:\ /Verify
(7) Copy ReAgent.xml in the label [System] to the label [Windows].
X:\windows\system32>copy F:\Recovery\ReAgent.xml C:\Windows
\System32\Recovery\ReAgent.xml
(8) When the [Overwrite] confirmation message appears, type "Yes".
(9) Exit Windows PE.
X:\windows\system32>wpeutil shutdown
12. Remove the USB memory from the unit.
13. Remove the top panel assembly. (Refer to
14. Set Bit1 of the DIP switch (S2201) on the MB-1204 board to OFF. (Refer to
Switch Settings".)
15. Install the top panel assembly.
16. Turn on the unit and check that the Windows starts.
17. Update the software. (Refer to
1-6-3.

Recovery by Replacing SSD Module

If recovery is not successful even after
may be defective. In that case, replace the SSD module and make settings after replacement. (Refer to
Module (M.2)" and "5-2-2. SSD Module (M.2
PWS-110RX1A
"5-4. Top Panel Assembly".)
"1-4. Software Update".)
"1-6-2. Recovery by Using the Windows PE"
Assembly)".)
"MB-1204 Board" in "1-2-1. Onboard
is performed, the SSD module
"5-16. SSD
1-26