Recovery By Using The Windows Pe - Sony PWS-110RX1A Service Manual

12. On the displayed window, execute the following command.
X:\windows\system32>diskpart
DISKPART>list volume
The following information is shown.
Volume ### Ltr Label
---------- --- ----------- ----- ---------- ------- --------- --------
Volume 0 C
Volume 1 D
Volume 2
Volume 3 E
Check the configuration of volumes.
• When the above information is shown, carry out steps from step 13.
• When the above information is not shown, confirm that Bit1 of the DIP switch (S2201) on the MB-1204
board is set to ON.
When this DIP switch is correctly set but the above information is not shown, execute the following command
to shut down the unit and recovery the system by using Windows PE. (Refer to
the Windows PE".)
DISKPART>exit
X:\windows\system32>wpeutil shutdown
13. Execute the following command.
DISKPART>exit
X:\windows\system32>E:
C:>cd Recovery
C:\Recovery>recovery.bat
14. After recovery has been completed, execute the following command.
E:\Revocery>wpeutil shutdown
The unit is shut down.
15. Remove the top panel assembly. (Refer to
16. Set Bit1 of the DIP switch (S2201) on the MB-1204 board to OFF. (Refer to in
17. Install the top panel assembly.
18. Turn on the unit and check that the Windows starts.
19. Upgrade the software. (Refer to
1-6-2.

Recovery by Using the Windows PE

If Windows does not start, carry out the following procedure for recovery.
PWS-110RX1A
Fs
Windows NTFS
Windows RE NTFS
SYSTEM FAT32 Partition
Recovery NTFS
"5-4. Top Panel
"1-4. Software Update".)
Type Size
Partition 98 GB
Partition 300 MB
100 MB
Partition 20 GB
Assembly".)
"1-2-1. Onboard Switch
Status Info
Healthy
Healthy Hidden
Healthy Hidden
Healthy Hidden
"1-6-2. Recovery by Using
Settings".)
1-24