Sony PWS-110RX1A Service Manual page 35

Preparation
• USB memory (capacity: 1 GB or more, for Windows PE)
• Windows PC
Procedure
1. Remove the top panel assembly. (Refer to
2. Set Bit1 of the DIP switch (S2201) on the MB-1204 board to ON. (Refer to
Switch Settings".)
3. Install the top panel assembly.
4. Connect the USB memory to the Windows PC and create bootable USB memory for Windows PE.
Note
Create Windows PE for Windows 10 64bit.
Use version "for Windows10" of Windows PE.
For details of creating bootable USB memory for Windows PE, contact your local Sony Sales Office/Service Center.
5. Connect the USB memory to the unit.
6. Press and hold the Delete key and turn on the unit.
BIOS setup screen is displayed.
7. Move to the [Save & Exit] tab by pressing the arrow keys on the keyboard.
8. Select the USB memory from [Boot Override].
The unit restarts.
Windows PE starts from the USB memory.
9. On the displayed window, execute the following command.
X:\windows\system32>diskpart
DISKPART>list volume
The following information is shown.
Volume ### Ltr Label
---------- --- ----------- ----- ---------- ------- --------- --------
Volume 0 C
Volume 1 E
Volume 2
Volume 3 F
Volume 4 D
Check the configuration of volumes.
Note
Different information may be shown depending on the operating environment.
10. Execute the following command to exit diskpart.
DISKPART>exit
PWS-110RX1A
"5-4. Top Panel
Fs
Windows
Windows RE
System
Recovery
WINPE
Assembly".)
"MB-1204 Board"
Type Size
in "1-2-1. Onboard
Status Info
1-25