1000Base-Zx Cwdm Sfp Specifications; 1000Base-Sx Ddi Sfp Specifications; Aa1419043-E6; Aa1419048-E6 - Nortel Passport 8600 Installation Manual

42 SFP specifications
For the 40 km CWDM SFPs, a minimum attenuation of 4 dB must be present
between the transmitter and receiver. To avoid receiver saturation, you must insert
a minimum attenuation of 4 dB when you test the CWDM SFP in loopback mode,
or use short runs of fiber with no intermediate CWDM OADM or CWDM OMUX.
1000BASE-ZX CWDM SFP specifications
For the 70 km CWDM SFPs, a minimum attenuation of 10 dB must be present
between the transmitter and receiver.
The part numbers of the 70 km models range from AA1419033-E5 to
AA1419040-E5.
1000BASE-ZX CWDM (70 km) SFP specifications
Parameter
Connectors
Cabling
Data rate
Line rate (8B/10B code)
Operating temperature range
Link optical power budget
Transmitter characteristics
Launch power
Receiver characteristics
Receiver sensitivity
Maximum input power
1000BASE-SX DDI SFP specifications
The following table describes the 1000BASE-SX DDI SFP, which has a reach
of up to 550 m using 50 µm MMF, and of 275 m using 62.5 µm MMF. This
SFP operates at 850 nm. The part number of this SFP is AA1419048-E6.
1000BASE-SX SFP DDI (550 m) specifications
Parameter
Maximum electrical power consumption
Connector
Copyright © 2007, Nortel Networks
.
Nortel Metro Ethernet Routing Switch 8600
Installation — SFP, XFP, and GBIC Hardware Components
NN46220-301 02.02 Standard
4.2 13 November 2007
ATTENTION
ATTENTION
Specifications
Duplex LC
SMF, 9 µm
1.0 Gbit/s
1.25 Gbit/s
0 to 60C
20 dB
-3.0 to 2.0 dBm
-23 dBm
-3.0 dBm
Specifications
1 watt (W)
Duplex LC