1000Base-T Sfp Specifications; 1000Base-Sx (Lc) Sfp Specifications - Nortel Passport 8600 Installation Manual

1000BASE-T SFP specifications
The 1000BASE-T SFP provides Gigabit Ethernet connectivity using a single
eight-pin RJ-45 connector. The 1000BASE-T SFP only operates at 1 gigabit
per second (1 Gbit/s) and does not support 100BASE-T or 10BASE-T
interfaces. The part number for this model is AA1419043-E6.
You must disable autonegotiation before operating the 1000BASE-T SFP.
By default, SFPs inserted into certain product-specific modules are set for
Autonegotiation = True.
The maximum current requirement of the SFP is 375 milliamperes (mA) at
5 volts (V).
The following table describes the 1000BASE-T SFP specifications.
IEEE 802.3z 1000BASE-T SFP specifications
Parameter
Standards
Connectors
Cabling
Distance
1000BASE-SX (LC) SFP specifications
The 1000BASE-SX SFP provides 1000BASE-SX Gigabit Ethernet
connectivity at 850 nm using multimode optical fiber. This SFP supports
full-duplex operation only. The part number for this model is AA1419013-E5.
The following table describes standards, connectors, cabling, and distance
for the 1000BASE-SX SFP.
IEEE 802.3z 1000BASE-SX (LC) SFP specifications
Parameter
Connectors
Cabling
Distance
Wavelength
Link optical power budget
Copyright © 2007, Nortel Networks
.
Nortel Metro Ethernet Routing Switch 8600
Installation — SFP, XFP, and GBIC Hardware Components
NN46220-301 02.02 Standard
4.2 13 November 2007
1000BASE-SX (LC) SFP specifications 39
ATTENTION
Specifications
IEEE 802.3z, IEEE 802.3ab
RJ-45
CAT5E or better UTP
Up to 100 m
Specifications
Duplex LC
•
62.5 µm MMF optic cable
• 50 µm MMF optic cable
• up to 275 m using 62.5 µm MMF optic cable
• up to 550 m using 50 µm MMF optic cable
850 nanometers (nm)
7.0 deciBels (dB)