Installing an SFP
Install an SFP to provide an interface between the switch and the network
cable.
Installing an SFP takes about 3 minutes.
Prerequisites
•
Procedure steps
Step
1
2
3
Copyright © 2007, Nortel Networks
.
Verify that the SFP is the correct model for your network configuration.
CAUTION
SFPs are keyed to prevent incorrect insertion. If the SFP resists
pressure, do not force it; turn it over, and reinsert it.
Action
Remove the SFP from its protective packaging.
Grasp the SFP between your thumb and forefinger.
As shown in the following figure, insert the device into the slot on
the module.
Apply a light pressure to the device until it clicks and locks into
position.
Nortel Metro Ethernet Routing Switch 8600
Installation — SFP, XFP, and GBIC Hardware Components
NN46220-301 02.02 Standard
4.2 13 November 2007
Installing an SFP 23