Procedure Job Aid: Xfp Models - Nortel Passport 8600 Installation Manual

34 10 Gigabit small form factor pluggable transceivers

Procedure job aid: XFP models

XFPs are hot-swappable input/output enhancement components designed
for use with Nortel products to allow 10 Gigabit Ethernet ports to link with
other 10 Gigabit Ethernet ports. Digital diagnostic monitoring (DDM) allows
real-time access to device operating parameters. All XFPs come with DDM
capability.
All Nortel XFPs use LC connectors to provide precision keying, low interface
losses, and space savings.
The following table lists and describes the Nortel XFP models. For
specifications for these XFPs, see
You can configure the XFP to operate in either LAN or WAN mode, depending
on the module (8683XLR is a LAN-only module, and 8683XZR is a LAN/ WAN
module). Model numbers ending in R denote a LAN interface; model numbers
ending in W denote a WAN interface.
XFP models
Model number
10GBASE-SR
10GBASE-LR/LW
Installation — SFP, XFP, GBIC, and OADM Hardware Components
Copyright © 2007, Nortel Networks
.
—End—
ATTENTION
CAUTION
Nortel recommends that you install only one 10GBASE-ZR/ZW
XFP per module due to cooling limitations on the 8683XLR and
8683XZR modules. Nortel further recommends the installation of
the XFP only in port 1. You can install a 10GBASE-SR, -LR/LW, or
-ER/EW in one or both of the remaining ports.
Product number Description
AA1403005-E5 850 nanometers (nm). The range is up to:
•
•
•
•
•
AA1403001-E5 1310 nm SMF. The range is up to 10 km.
Nortel Ethernet Routing Switch 8600
NN46205-305 01.02 Standard
4.1 16 November 2007
"XFP specifications" (page
22 m using 62.5 micrometer (µm), 160
megaHertz times km (MHz-km) MMF
33 m using 62.5 µm, 200 MHz-km MMF
66 m using 62.5 µm, 500 MHz-km MMF
82 m using 50 µm, 500 MHz-km MMF
300 m using 50 µm, 2000 MHz-km MMF
71).