The no logging remote enable command is executed in the Global
Configuration command mode.
logging remote address command
The logging remote address command sets the remote server for
receiving the syslog messages. The syntax for the logging remote
address command is:
logging remote address <A.B.C.D>
The logging remote address command is executed in the Global
Configuration command mode.
"logging remote address parameters" (page 21)
for the logging remote address command.
logging remote address parameters
Parameters and variables
<A.B.C.D>
The default address is 0.0.0.0.
no logging remote address command
The no logging remote address command clears the IP address of
the remote server. The syntax for the no logging remote address
command is:
no logging remote address
The no logging remote address command is executed in the Global
Configuration command mode.
logging remote level command
The logging remote level command sets the severity level of the
logs sent to the remote server. The syntax for the logging remote level
command is:
logging remote level {critical | informational | serious |
none}
The logging remote level command is executed in the Global
Configuration command mode.
" logging remote level parameters" (page 22)
the logging remote level command.
Copyright © 2005 - 2007, Nortel Networks
.
Description
Specifies the IP address of the remote server in
dotted-decimal notation.
Nortel Ethernet Routing Switch 5500 Series
Configuration - System Monitoring
NN47200-505 03.01 Standard
5.1 27 August 2007
Remote logging 21
describes the parameters
describes the parameters for