Table B-13. Arguments For The Stats -T Command - Nortel 5399 User Manual

Book A
Model 5399 Remote Access Concentrator Network Administrator's Guide for UNIX
For 5399s that support internal CSUs, the stats –T command displays an
extensive set of T1/PRI line statistics, alarm indications, and other line
performance monitoring information. This information is obtained
through the 5399 RAC implementation of the Facilities Data Link (FDL)
protocol and from the PRI module. Table B-13 describes the arguments
for stats –T. The syntax is as follows:
annex: stats –T {clear|current|total|all}
Table B-13. Arguments for the stats –T Command
Argument Description
current Displays T1/PRI statistics information for the current
15-minute interval.
total Displays a summary of T1/PRI statistics information for
the last 24 hours. This option is available only if the pri
fdl_type parameter is set to att (see Table A-7 on page
A-54).
all Displays the T1/PRI statistics for each valid interval. There
are up to 96 intervals (15 minutes per interval) for a
24-hour period. The most recently recorded interval is
displayed as the highest-numbered one. This option is
available only if the pri fdl_type parameter is set to att (see
Table A-7 on page A-54).
clear Clears the alarm condition saved in the history buffer. Also
clears the previous 24-hour statistics. Once the alarm
history buffer is cleared, the next alarm event is captured
and stored in the history buffer. Subsequent alarm events
will not overwrite the history buffer. This option is
available only to the Superuser.
Chapter 1 Network Administration
A-41