7. HEIGHT OF THE FEED DOG
If the feed dog does not come up over the needle
plate enough, it will result in insufficient and/or
uneven feed of fabrics.
Check
1. The feed dog should come up over the needle
plate (0.9-1.0 mm) when its highest position.
If it does not come up enough, adjust as follows:
Adjustment
1. Remove the needle plate.
2. Loosen the nut (a) behind the feed dog.
• If the feed dog is too low;
Turn the adjusting screw (b) (2.5mm hex. wrench)
clockwise.
• If the feed dog is too high;
Turn the screw (b) counterclockwise.
Re-tighten the nut (a) so that the screw (b) will not
move.
3. Re-check the height of feed dog.
8
Settings
1
2 View from backside
0.9-1.0 mm
b
a