Embroidery Service Menu Function No.2 - Embroidery Test; Embroidery Service Menu Function No.3 - Test Design - Husqvarna VIKING Designer Jade Service Manual

Embroidery Service Menu
Function No.2 - Embroidery
Test
Entering Function No 2.
1. Press Stitch selection buttons "
2. The display shows the embroidery service menu
function No.2 according to below picture.
Belt tension test : Test the belt tension for
booth x- and y-motor
Is used to test the belt tension for booth x- y-motor.
By pressing the - or + button of the Stitch width
button, switches to 3 functinos: off (idle mode), belt
-x, belt -y.
Full calibration : Full calibration test
When the OK button is pressed a full calibration of
the embroidery unit shall be performed.
After calibration the unit shall go to center position.
Park : Park position test
When the ALT button is pressed, the embroidery unit
shall go to the park position.
Test position : Test position test
When the Delete button is pressed the embroidery
unit shall go to the test position.
Service Program
Embroidery Service Menu
Function No.3 - Test Design
Entering Function No 3.
".
1. Press Stitch selection buttons "
2. The display shows the embroidery service menu
function No.3 according to below picture.
Reload test embroidery
When Delete button is pressed, the built in test
embroidery shall load.
When pressing the Delete button, the test
embroidery shall reload.
Embroidery position
By pressing the - and + button of the Stitch width
button, you can select position of the test embroidery.
Pos 1 means top left quadrant , pos 2 means top
right quadrant, pos 3 means lower left quadrant and
pos 4 means right quadrant.
".
1 2
3 4
29