10. POSITION OF NEEDLE POINT LIMITING PLATE
The needle point limiting plate is protecting the
needle hits the needle plate.
Check and adjust as follows.
Check
1. Set the pattern to [Straight stitch No.0] and set the
needle position to the extreme right (3.5).
2. Remove the presser foot and light cover.
3. Check the gap between the needle point limit-
ing shaft (a) and limiting plate (b) should be 0.2-
0.25mm.
Adjustment
1. Loosen the screw (c).
2. Insert the 0.2 mm gauge and slide the limiting
plate (b) to the right.
3. Holding this position, tighten the screw (c).
Settings
0.25mm
a
0.2mm gauge
c
b
b
11