Accessory Use - Safety 1st Grow and Go ARB Manual

Accessory Use

3
For Use in Rear-Facing
or Forward-Facing Mode
Harness Covers
Harness covers help provide comfort to
the neck.
If the harness covers will not allow
proper positioning of the chest clip or
interfere with getting a tight enough
harness fit for a smaller baby, remove
and do not use.
Store until your child is large enough
to use these harness covers while
maintaining a properly fitting harness.
There are different harness cover styles
depending on your model.
To remove harness covers with
fastening strips, pull the fastening
strips apart and pull them off of the
harness strap.
To remove harness covers without
fastening strips, unhook the harness
strap from splitter plate, pull harness
strap out of the upper harness slots and
remove harness covers.
Rethread harness strap and attach the
harness strap loops to the splitter plate.
For Use in Rear-Facing
or Forward-Facing Mode
Buckle Cover
(on select models)
To remove buckle cover, slide the ends
out of the buckle strap slot in pad. Pull
up and off of the buckle.
To install buckle cover, slide buckle
cover over buckle and tuck ends of
buckle cover into buckle strap slot in
pad.
Removable Cup Holders
(on select models)
The cup holders are top-rack
dishwasher safe.
To remove cup holder, twist the cup
holder counterclockwise. Pull it out of
slot in shell.
To install cup holder, align tabs on
bottom of cup holder with slots in shell.
Twist clockwise to lock in place.
continued on next page
4