Table of Contents
Advertisement
49
6
7
Make Car Seat Flush
Against Vehicle Seat
Put the child restraint into
Position 1.
Only use the semi-reclined
position if necessary to install
the child restraint flush against
the vehicle seat back.
Vehicle seat back must be
upright.
NOTE: If your vehicle seat has
a headrest that interferes
with achieving a flush car
seat fit, check your vehicle
owner's manual to see if it can
be removed, adjusted, or if there
are other possible seating
locations.
Loosely Attach Tether Hook
to Vehicle's Tether Anchor
Check vehicle owner's manual
for specific location.
8
9
Depending on Your Model:
Attach UAS Connectors
or Hooks to Vehicle's UAS
Anchors in Seat Bight
Review your vehicle owner's
manual for UAS anchor locations
and UAS belt use.
Fasten one connector or hook to
one vehicle UAS anchor bar.
Then repeat for the second
connector or hook on the other
side of the car seat.
For UAS Connectors: Make sure
arrows on connectors are facing
up.
Tighten Belt
Place hand in child restraint.
Firmly push child restraint down
while pulling the free end of the
belt parallel with the belt path
through the belt path opening as
shown.
continued on next page
50
Advertisement
Table of Contents
