Rear-Facing UAS Install
37
Before you begin installing the seat
into your vehicle, did you check:
Your child's weight and height?
See page 31.
Your child's fit? See page 10.
Do you need to make adjustments to the
harness/headrest height or the buckle
position?
1
2
1
2
Install Anti-Rebound Bar
You must install the anti-
rebound bar to use this seat in
Rear-Facing
Mode. See page
20.
1
2
Remove UAS Belt from
Storage Location
Or if the UAS belt was used
Forward-Facing, remove it
from the Forward-Facing belt
path so both connectors or both
hooks are on the same side of
the seat.
3
Adjuster
4
Pull UAS Belt Across the
Seat
It must be under the seat pad,
1
in front of the buckle, and go
2
out through the other belt path
opening.
Do not twist belt.
5
Adjuster
6
1
2
Locate Rear-Facing Belt
Path
1
2
Thread the connector or hook
without the adjuster closest
to it through the
Rear-Facing
Belt Path
opening as shown.
Finished UAS Belt Routing
Place Car Seat Rear-
Facing in Back Seat
The anti-rebound bar should
make contact with the vehicle
seat back, but it does not need
to be flush with the vehicle seat
back.
continued on next page
38