Cleaning Parts Of Car Seat & Installing Seat Pad Set - Safety 1st Grow and Go ARB Manual

All-in-one car seat
Hide thumbs Also See for Grow and Go ARB:
Table of Contents

Advertisement

65
7
8
9
Pull Pad Off Sides and
Bottom of Shell
Pull Pad Down and Off of
Bottom of Harness Holders
Pull up to remove completely.
From Top of Seat, Pull Pad
Off of Shell
Cleaning Parts of Car Seat & Installing
Seat Pad Set
Cleaning Pad and Accessories
Machine wash separately with cold water on a gentle cycle. Make
sure the harness covers are closed so the fastening strips are not
exposed. Do not use bleach. Tumble dry separately for 10-12 minutes
on low heat. Remove immediately.
Cleaning Harness Strap
Check the harness straps often for any wear or damage.
Do not fully pull the harness strap out of the car seat. Leave
it threaded in the hip harness slots. If removed, you will not be
able to rethread it.
Spot clean using warm sudsy water and damp cloth. Spilled food and
liquids on the car seat may result in mold or bacterial growth over
time. These spills could also attract insects or rodents.
Cleaning Buckle & Car Seat Shell
Spot clean using warm sudsy water and damp cloth. Do not submerge
into water.
Do not use the child restraint without the seat pad or with
damaged harness straps.
1
OR
2
Gently Pull Headrest Pad
onto Headrest
3
OR
There is one at the headrest/harness adjustment handle.
Slide the fabric tab into the slot in headrest as shown.
66
Adjust
Headrest
to Highest
Position
Headrest Style 1: Place
Elastic Straps on Headrest
Pad Around Headrest/Harness
Adjustment Levers
Headrest Style 2: Locate Pad
Fabric Tab Slot in Headrest
continued on next page

Advertisement

Table of Contents
loading

This manual is also suitable for:

Grow and go arb sportMultifit arbContinuum arb

Table of Contents