Rear-Facing Mode; Rear-Facing Vehicle Belt Install - Safety 1st Grow and Go ARB Manual

Rear-Facing Mode

31
2.3-18 kg (5-40 lb) and
48-102 cm (19-40 in.)
Lap/Shoulder Lap Belt
Belt
Never install a rear-facing child restraint in the
front seat of a vehicle equipped with an active
frontal airbag.
Do not use the tether for rear-facing mode.
Secure tether strap to its storage location.
Do not use the UAS belt along with the vehicle lap
or lap/shoulder belt.
Check the vehicle belt or the UAS belt before
each use. Use only if the belt can be tightened
properly and locked securely in place.
Do not fasten multiple UAS connectors or hooks on the same
lower/UAS anchor bar in the vehicle.
The anti-rebound bar must be used in rear-facing mode.
Even when unoccupied, this child restraint must be firmly
secured to the vehicle with a UAS belt or with the vehicle seat
belt.
This child restraint MUST always face the rear of the vehicle until
the child is at least 1 year old and weighs 10 kg (22 lb).

Rear-Facing Vehicle Belt Install

UAS Belt
1
2
Before you begin installing the seat
into your vehicle, did you check:
Your child's weight and height?
See page 31.
Your child's fit? See page 10.
Do you need to make adjustments to the
harness/headrest height or the buckle position?
Install Anti-Rebound Bar
You must install the anti-
rebound bar to use this seat
in Rear-Facing
page 20.
Place Car Seat Rear-Facing
in Back Seat
The anti-rebound bar should
make contact with the vehicle
seat back, but it does not need
to be flush with the vehicle seat
back.
continued on next page
32
Mode. See