Safety 1st Grow and Go ARB Manual page 26

1
45 2
3
6
7
8
9
Route Vehicle Belt
Thread the vehicle belt through
Forward-Facing Belt Path
opening.
Pull it across the seat. Then
thread it through the other belt
path opening.
Do not twist belt.
1
2
Buckle the Vehicle Belt
3
If your car's vehicle belt has a
switchable retractor, use it to lock
the vehicle belt.
For information about switchable
retractors, see page 27 or review
your vehicle owner's manual.
Tighten Belt
Place hand in child restraint.
Firmly push child restraint down
while pulling the shoulder belt or
free end of the lap belt parallel
with the belt path through the
belt path opening as shown.
Tighten Tether
Push firmly on the back of the
seat and pull the tether strap to
remove all slack and create
tension on the strap.
1
2
3
10
If it moves more than 2.5 cm (1 in.),
1
A. Putting your knee in the seat and pulling the belt tighter.
2
3
B. Reinstalling the child restraint.
C. Changing to a different seating location.
D. Switching to the UAS belt installation if UAS anchors are
available in your vehicle.
Check Belt Tightness
Hold child restraint at the belt
path with your weaker hand.
Push and pull from side to side.
It should not move more than
2.5 cm (1 in.).
you can try:
Finished!
Check the tightness of the install
often to make sure it has not
loosened.
Securing Child in Car Seat
To properly secure your child in
the car seat, see pages 52-54.
Check your child's fit often
and make any needed
adjustments to the car seat
as they grow.
46