Figure 4-3. Browser-Based Setup Wizard, Second Screen - NETGEAR RT311 Reference Manual

Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers
Click on Next to go to the ISP Parameters screen, shown in
8.
Figure 4-3. Browser-based Setup Wizard, second screen
This screen determines whether a login program will be run.
If your service provider does not require a login program, leave Encapsulation as
a.
Ethernet and proceed to Step 9.
If your service provider uses PPP over Ethernet (PPPoE), select Encapsulation as
b.
PPPoE, and enter these additional parameters:
• If your connection supports multiple ISPs, enter the Service Name of the one you use.
Otherwise leave Service Name blank.
• Enter the user name and password provided by your ISP. These fields are case
sensitive.
• If you wish to change the login timeout, enter a new value in seconds.
Proceed to Step 9.
If your service provider is RoadRunner AND you are required to run a RoadRunner
c.
login program, leave Encapsulation as Ethernet and select Service Type as either
RR-Manager or RR-Toshiba. Enter these additional parameters:.
• If your cable modem is Toshiba, select RR-Toshiba. Otherwise select RR-Manager.
• Enter the user name and password provided by your ISP. These fields are case
sensitive.
4-4
Figure 4-3
Using Your Browser for Configuring the Router
below: