Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers
Local Network Hardware Requirements
The Model RT311 or RT314 Internet Access Gateway Router is intended for use in a network of
workstations that are interconnected by twisted-pair Ethernet or Fast Ethernet cables.
Each workstation in the network must meet the following requirements:
•
An Ethernet Network Interface Card (NIC) is installed.
•
Workstations are connected by a hub or switch. If all workstations on the network will not run
at the same speed (10 Mbps or 100 Mbps), a dual-speed hub or switch must be used. The
Model RT314 router provides a switch capable of either 10 Mbps or 100 Mbps operation.
•
Links operating at 100 Mbps are connected with Category 5 cable.
•
The access device to be shared (cable modem or DSL modem) has a standard 10BASE-T
Ethernet interface.
2-2
Installing and Connecting the Router