NETGEAR RT311 Reference Manual page 103

Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers
If the path is not functioning correctly, you could have one of the following problems:
• Wrong physical connections
— Make sure the Local LNK/ACT LED is on. If the LNK/ACT LED is off, follow the
instructions in
— Check that the corresponding Link LEDs are on for your network interface card and
for the hub ports (if any) that are connected to your workstation and router.
• Wrong network configuration
— Verify that the Ethernet card driver software and TCP/IP software are both installed
and configured on your PC or workstation.
— Verify that the IP address for your router and your workstation are correct and that the
addresses are on the same subnet.
Troubleshooting
"LNK/ACT LEDs Not On" on page 9-2.
9-5