Table of Contents
Advertisement
62
Finalizing the Installation
LP Conversion Instructions
This conversion kit shall be installed by a qualified service agency in accordance with the
manufacturer's instructions and all applicable codes and requirements of the authority having
jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion, or
production of carbon monoxide may result causing property damage, personal injury, or loss
of life. The qualified service agency is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation of the converted appliance is
checked as specified in the manufacturer's instructions supplied with the kit.
Caution:
The gas supply shall be shut off prior to disconnecting the electrical power, before
proceeding with the conversion.
Note: Convert the appliance prior to installing the gas line to ensure proper gas use.
The GSR Stepper Motor Kit (4-pack = 94400999, single = 250-01463) is required for converting this
appliance to LP. The kit contains the stepper motor (regulator) and Torx wrench. The burner
orifices, pilot orifice, and burner gaskets are shipped with the appliance.
1. Remove the barrier and glass. Remove the logs and embers (if installed - page 50)
2. Remove the burners following the directions below.
Lift the center burner and remove it from the firebox. When replacing the burner make sure it is properly
located.
Lift the outer burner and remove it from the firebox. When replacing the burner make sure it is properly
located.
© Travis Industries
(for qualified installers only)
WARNING
NOTE: When reinstalling the center burner make sure that the
holes on the left end of the burner engage the two locating pins.
1/12/2023 - 1556
PB 36CF ST Install
Advertisement
Table of Contents
