Table of Contents
Advertisement
44
Finalizing the Installation
Air Shutter Adjustment
Let the heater burn for fifteen minutes (make sure the logs and glass are in place). The flames should be yellow
with no sooting. Adjust the air shutter, if necessary, to achieve the correct looking flame.
Air Shutter Adjustment
7.
Adjust the flame to its highest position - the flames should not contact the top of the firebox. Check the flame on
low setting. The flames should burn off of each burner hole. If the heater does not work correctly, contact your
Travis dealer for a remedy.
8.
Give this manual to the homeowner for future reference and fully explain the operation of this heater. For
comprehensive operating and maintenance instructions, refer to the Owner's Manual.
ACID WASH WARNING: Make sure any masonry that has been treated with acid wash has been properly neutralized
(this is used primarily with brick faces). Acid wash (muriatic acid) is used to remove excess mortar.
© Travis Industries
(for qualified installers only)
1/12/2023 - 1556
PB 36CF ST Install
Advertisement
Table of Contents
