Table of Contents
Advertisement
Invacare® Storm®⁴ Series
1.
Loosen screws (1).
2.
Set angle for armrest.
3. Re-tighten screws. Make sure that Nordlock washers
used are re-inserted.
5.4.3 Adjusting the width of the parallel sliding armrests
The parallel sliding armrests can be adapted to the backrest
in eight widths.
Tools:
•
4 mm Allen key
38
1.
Undo the bolts on both sides of the backrest cover (1).
The photograph only shows the bolts on the left-hand
side.
2. Remove the backrest cover (2).
3.
On the torque support, loosen the locating pin (3) bolt
(2) with the Allen key.
4. Reduce the load on the armrest by raising it slightly and
then remove the locating pin.
1529686-AA
Advertisement
Table of Contents
