Adjusting Powered Chin Control; Adjusting Extremity Control Joystick; Adjusting Joysticks And Switches On Linkage - Invacare Storm4 Series User Manual

Invacare® Storm®⁴ Series

5.7 Adjusting Powered Chin Control

WARNING!
Risk of Injury or Death
Small parts can lead to choking hazard that may
result in injury or death.
– Do not remove any small parts.
– Closely supervise children, pets or people with
physical/mental disabilities.
CAUTION!
Risk of Injury and Damage
Remaining burrs and missing end caps after
modifications on rods, such as shortened rod, can
lead to injury or damage.
– Deburr cut after cutting excessive length.
– Re-install end cap after deburring.
– Check end cap for tight fitting.

5.7.1 Adjusting Extremity Control Joystick

See "Adjusting Joystick Orientation" in 5.6.1 Adjusting
Extremity Control Joystick, page 44.

5.7.2 Adjusting Joysticks and Switches on Linkage

Positioning Joysticks / Switches
Risk of damage to screws
If you tighten screws to an improper torque, they
might either come loose or get damaged.
– Tighten the screws to a torque of 3 Nm ± 10 %.
46
• 4 mm Allen key
1. Loosen screws A.
2. Move joystick or switch to desired position on the
linkage.
3. Tighten screws.
Positioning Piko Buttons
Risk of damage to screws
If you tighten screws to an improper torque, they
might either come loose or get damaged.
– Tighten the screws to a torque of 3 Nm ± 10 %.
• 4 mm Allen key
• 7/16 inch wrench
Fig. 5-19
1529686-AA