Table of Contents
Advertisement
Depending on the side, the screw is accessible from
the front or the rear.
•
8 mm Allen key
1. Loosen screw (1).
2. Adjust armrest to required position.
3. Re-tighten screw.
4. Repeat this procedure for the second armrest.
1529686-AA
5.4 Adjusting Parallel Sliding Armrests (Until
April 2017)
5.4.1 Setting the height of the parallel sliding armrests
The height of the parallel sliding armrest is set using the
armrest angle.
1.
Release the knob to adjust the armrest angle (1).
2.
Set the angle for the armrest.
3. Retighten the knob.
After adjusting the armrest height, the angle of the armpad
needs to be adjusted. Refer to 5.4.2 Adjusting angle of
armpad on parallel sliding armrests, page 37.
5.4.2 Adjusting angle of armpad on parallel sliding
armrests
•
5 mm Allen key
Setup
37
Advertisement
Table of Contents
