Adjust The Recording Level - Sony MDS-S500 Instruction Manual

Mini disc deck
Table of Contents

Advertisement

Machine Translated by Google

Adjust the recording level

You can adjust the recording level as needed.
LEVEL/DISPLAY/CHAR
1 Perform steps 1 to 6 of
"Recording" (page 13).
2 Play the part with the highest playback level
(the part with the loudest sound) of the
sound source.
3 LEVEL/DISPLAY/CHAR
Press (DISPLAY on the remote
control) to display the level of
the input signal.
4 Turn the AMS knob ( press the LEVEL +/–
of the remote controller repeatedly) to
adjust the recording level. When the
playback level is the highest, the peak
level meter "OVER" should not always
be lit. Adjust.
Adjust so that this is not always lit
5 Stop playing the sound source you want to record
6 When you start recording as it is
AMS
You can also adjust the recording level with the z remote
control. Z Press LEVEL +/- repeatedly during recording or while
recording is paused .
z You can use the peak hold function. The state
of the peak level meter when the input signal level
is the highest can be stopped and displayed until a
signal exceeding that level is input. 1 Press MENU /
NO while stopped.
2 Turn the AMS knob (press ./> on the remote
3 Turn the AMS knob (press ./> on the remote
4 Turn the AMS knob (press ./> on the remote
5 Press MENU / NO. To
stop the peak hold function, select "P. Hold Off"
in step 4.
Note
You can only increase the volume up to + 12.0dB
for analog recording and + 18.0dB for digital
recording. If the output level of the connected device
is low, you may not be able to maximize the recording level.
z You can return the recording level to the default value. If
you press CLEAR instead of turning the AMS knob in step
4, the default value will be restored.
Ru
Performs step 8 and subsequent steps
of "Recording" (page 13).
control repeatedly) to display "Setup?", And
press the AMS knob or YES.
control repeatedly) to display "P. Hold
Off" (default setting), and then press the AMS
knob or YES.
control repeatedly) to select "P. Hold On", and
then press the AMS knob or YES.
19

Advertisement

Table of Contents
loading

Table of Contents