Table of Contents
Advertisement
The following information describes how to remove and install the drive assembly and to repair a worn or
damaged shaft seal.
Note: Before installing this product, read and follow all warning notices and instructions on page ii.
Pump Disassembly
WARNING — Always disconnect power to the pool pump at the circuit breaker and disconnect the
communication cable before servicing the pump. Failure to do so could result in death or
serious injury to serviceman, pool users or others due to electric shock.
Read all servicing instructions before working on the pump.
WARNING — DO NOT open the strainer pot if pump fails to prime or if pump has been operating without
water in the strainer pot. Pumps operated in these circumstances may experience a build up
of vapor pressure and may contain scalding hot water. Opening the pump may cause serious
personal injury. In order to avoid the possibility of personal injury, make sure the suction and
discharge valves are open and strainer pot temperature is cool to touch, then open with
extreme caution.
CAUTION — Be sure not to scratch or mar the polished shaft seal faces; seal will leak if faces are
damaged.
Required tools:
•
½ inch open end wrench.
•
7/16 inch open end wrench.
•
Flat blade screwdriver.
Drive Assembly Removal and Installation
To remove the IntelliPro drive assembly and control panel from the pump's motor assembly:
WARNING - To avoid dangerous or fatal electrical shock hazard, switch OFF power to motor before working
on pump or motor.
1. Disconnect the RS-485 communication cable from the pump.
2. Open the control panel cover.
Removal and Replacement
Section 5
IntelliPro Installation and User's Guide
27
Advertisement
Table of Contents
