Connecting Intellipro 4 To An Easytouch System - Pentair Pool Products STA-RITE IntelliPro 4x160 Installation And User Manual

Connecting IntelliPro 4 to an EasyTouch System

The IntelliPro 4 can be controlled by an EasyTouch system via the RS-485 communication cable
(P/N 350122). In this configuration, EasyTouch starts, stops and controls the speed of the IntelliFlo 4
pump. When the EasyTouch does this, it rewrites the IntelliFlo 4 memory, which can take several seconds.
This causes a delay after a command is given on the EasyTouch control panel until the IntelliFlo 4 physically
responds.
The IntelliPro 4 control panel is disabled when communicating with the EasyTouch system. Note that
IntelliTouch will not start communicating with the IntelliFlo 4 until the pump is assigned to a circuit. The
IntelliPro 4 default pump address is one which is the only address that works with EasyTouch. See page 6
for details about how to check the address and change if necessary. For more information, refer to the
EasyTouch User's Guide (P/N 520584).
To connect the IntelliPro 4 communication cable to EasyTouch load center:
1. - Switch the main power off to the EasyTouch load center.
CAUTION
2. Unlatch the two enclosure door spring latches, and open the door.
3. Remove the two retaining screws securing the high voltage cover panel, and remove it from the
enclosure.
4. Loosen the two access screws securing the control panel.
Control panel
access screw
EasyTouch Load Center (front view)
Control panel
access screw
High voltage
cover panel
IntelliPro Installation and User's Guide
9