Table of Contents
Advertisement
General
Information
Thank you for purchasing your
Hydromatic
®
pump. To help
ensure years of trouble-free
operation,
please
following manual carefully.
Before Operation:
Read the following instructions
carefully. Reasonable care and
safe methods should be practiced.
Check
local
codes
requirements before installation.
Attention:
This manual contains important
information for the safe use of
this product.
Read this manual
completely before using this
product and refer to it often for
continued
safe
product
DO NOT THROW AWAY OR
LOSE THIS MANUAL. Keep it
in a safe place so that you may
refer to it often.
WARNING: Before handling
these pumps and controls,
always disconnect the power
first. Do not smoke or use
sparkable electrical devices or
flames in a septic (gaseous) or
possible septic sump.
Pump
Warning
To reduce risk of electrical shock:
1. Risk of Electrical Shock:
This pump has not been
investigated
for
swimming pool areas.
2
2. Risk of Electrical Shock:
Connect only to a properly
grounded receptacle.
Septic tank is to be vented
in
accordance
plumbing codes.
read
the
Do not smoke or use sparkable
electrical devices or flame in a
septic (gaseous) or possible
septic sump.
If a septic sump condition
and
exists and if entry into sump is
necessary, then (1) provide
proper safety precautions per
OSHA requirements and (2)
do not enter sump until
these precautions are strictly
adhered to.
Do not install pump in location
classified as hazardous per
use.
N.E.C., ANSI/NFPA 70 - 1999.
Failure to heed above cautions
could result in injury or death.
Pump
Installation
These
must be followed for satisfactory
performance of your pump.
Before
your
local
plumbing codes.
1. Provide proper sump.
Minimum Sump Diameter
SW/SD/VS50
SW33
SD/VS33
use
in
with
local
important
instructions
installation,
check
electrical
and
18"
18"
12"
Approx. Turn-On Level
SW33A
9
SD33A
7
VS33A
8
Approx. Turn-Off Level
SW33A
3
SD33A
3
VS33A
3
Approx. Turn-On Level
SW50A
9
SD50A
7
VS50A
7
Approx. Turn-Off Level
SW50A
3
SD50A
3
VS50A
4"
2. Make sure float (Models
SW33/50 and VS33/50) hangs
free. It should not come into
contact with side or bottom of
sump.
3. Make sure sump is free of
string, cloth, nails, gravel, etc.
before installing pump.
4. Do not set pump directly on
the bottom of sump if it is not
solid.
Raise the pump by
using bricks or concrete blocks
underneath it.
5. Use steel or plastic pipe for all
connecting
lines
pump and sewer outlet.
NOTE: Some city regulations
do not allow installing a
pump with plastic pipe.
Check local regulations.
6. Hydromatic
check
should
be
installed
discharge pipe, at least twelve
inches above the discharge
outlet of the pump.
1
/
"
2
3
/
"
8
3
/
"
8
7
/
"
8
7
/
"
8
7
/
"
8
1
/
"
2
7
/
"
8
1
/
"
2
1
/
"
2
3
/
"
8
between
valve
in
Advertisement
Table of Contents
