Connecting Intellipro 4 To An Intellitouch System - Pentair Pool Products STA-RITE IntelliPro 4x160 Installation And User Manual

12

Connecting IntelliPro 4 to an IntelliTouch System

The IntelliPro 4 can be controlled by an IntelliTouch system via the RS-485 communication cable
(P/N 350122). In this configuration, IntelliTouch starts, stops and controls the speed of the IntelliPro 4
pump. When the IntelliTouch does this, it rewrites the IntelliPro 4 memory, which can take several seconds.
This causes a delay after a command is given on the IntelliTouch control panel until the IntelliPro 4 physically
responds.
The IntelliPro 4 control panel is disabled when communicating with the IntelliTouch system. Note that
IntelliTouch will not start communicating with the IntelliPro 4 until the appropriate pump address is assigned
to a circuit. The IntelliPro 4 default pump address is one. See page 6 for details about how to check the
address and change if necessary. For more information, refer to the IntelliTouch User's Guide
(P/N 520102).
To connect the IntelliPro 4 communication cable to IntelliTouch load center:
1. - Switch the main power off to the IntelliTouch load center.
CAUTION
2. Unlatch the IntelliTouch load center front door spring latches, and open the front door.
3. Remove the cover-panel screws securing the high voltage cover-panel, and remove it from the
enclosure.
4. Loosen the two control panel access screws and fold down the outdoor control panel.
5. Insert the two-wire cable into plastic grommet on the bottom of the enclosure and route the wire up
through the low voltage raceway to the Personality board.
Cover-panel
screw
(Cover-panel
removed)
IntelliPro Installation and User's Guide
Access screw
IntelliTouch Load Center
Personality Board
Low voltage raceway
Plastic grommet