Table of Contents
Advertisement
16
Adjusting the pump speed
IntelliPro 4 can be adjusted to run at any speed between 400 RPM and 3450 RPM.
To adjust the pump speed
1. Ensure that the pump is powered on and the green power LED is on.
2. Press the Start button to start the pump if the pump is not running.
3. Press the UP/Down button to increase or decrease the pump speed.
•
10 RPM increments: Press and quickly release the Up/Down button to
increase or decrease the speed in 10 RPM increments.
•
20 RPM increments: Press and hold the Up/Down button to continuously
increase or decrease the pump speed.
4. Saving an adjusted speed: To save the newly adjusted pump speed, press the
desired speed buttons to assign the current speed. Four new pump speeds can be assigned to Speed
buttons (1-4).
5. Press the Speed button that is assigned to the adjusted speed.
Starting the pump
To start the pump
1. Ensure that the pump is powered on and the green power LED is on.
2. Press the Start button (LED on) to start the pump.
Note: When the pump is using a modified speed and is powered down, the next time the pump is
powered up, the pump will use that same speed.
Stopping the pump
To stop the pump
•
Press the Stop button to stop the pump.
Note: The pump can automatically restart if the communication cable is connected.
Setting the pump communication address
The IntelliPro 4 communication address can be set to numbers 1, 2 ,3 or 4.
To set the address
1. Be sure the pump is powered on (green LED on) but not running.
2. Press and hold the Start and Stop button simultaneously for three seconds. The red Alarm LED
should start flashing. The LED for the currently active communication address should illuminate.
3. Release the Start and Stop buttons.
4. The active communications address in indicated by the LED's above the Speed buttons; Speed 1 for
address 1, Speed 2 for address 2 etc.
IntelliPro Installation and User's Guide
Up/Down button
Advertisement
Table of Contents
