Table of Contents
Advertisement
This section describes how to use the IntelliPro pump control panel.
- NEVER run pump dry. Running pump dry may damage seals, causing leakage and
CAUTION
flooding. Fill pump with water before starting motor.
Before removing trap cover:
1. STOP PUMP before proceeding.
2. CLOSE GATE VALVES in suction and discharge pipes.
3. RELEASE ALL PRESSURE from pump and piping system.
4. NEVER tighten or loosen clamp while pump is operating!
- If pump is being pressure tested, be sure pressure has been released before removing trap
WARNING
cover.
Do not block pump suction. To do so with body may cause severe or fatal injury. Small children using pool
must ALWAYS have close adult supervision.
Fire and burn hazard:
leaves, debris, or foreign matter to collect around the pump motor. To avoid burns when handling the motor,
let it cool for 20 minutes before trying to work on it. An automatic internal cutoff switch protects the motor
from heat damage during operation.
Maximum ambient temperature for motor operation must not exceed maximum ambient
NOTICE:
temperature rating on motor model plate.
Setting the pump preset speed
IntelliPro operates using one of the preset speeds. Use the speed buttons to select the preset speeds.
To set the pump speed
1. Ensure that the pump is powered on and the green power LED is on.
2. Press the desired speed button (1- 4) for less than three seconds to select the preset pump speed.
When the selected speed button is pressed, the LED is on. The pump preset buttons and speeds are:
Speed 1 button - 750 RPM
Speed 2 button - 1500 RPM
Speed 3 button - 2350 RPM
Speed 4 button - 3110 RPM
3. Press the Start button to start the pump using the selected speed if necessary.
Modern motors run at high temperatures. To reduce the risk of fire, do not allow
Section 3
Operation
IntelliPro Installation and User's Guide
15
Advertisement
Table of Contents
