Table of Contents
Advertisement
4
IntelliPro Operator Control Panel
The IntelliPro operator control panel provides manual speed controls for the pump. There are four preset speed
buttons that can be selected. The Up and Down button is used to adjust the pump speed. The selected speed
can be saved and assigned to one of the speed buttons.
Controls and LEDs
Speed 1, Speed 2, Speed 3, and Speed 4 button/LED:
1
preset pump speed. The pump preset speeds are: Speed 1 (750 RPM), Speed 2 (1500 RPM), Speed 3
(2350 RPM), and Speed 4 (3110 RPM). The speed button LED is on when the selected button is pressed.
If the pump is running and the Up/Down button is used to adjust the speed, the selected speed LEDs will go
off. For more about using the speed buttons, see page 7.
While the pump is running, press the Up or Down button to increase or decrease the
Up/Down button:
2
pump speed. To save the new pump speed, press any one of the four speed buttons for three seconds to
assign the speed to the selected button (the LED will be on). Four adjusted pump speeds can be assigned
to the speed buttons. When the pump is using an adjusted speed and the pump is powered down, the next
time the pump is powered up the pump will use the same speed. For more about using the Up/Down
button, see page 7.
Starts the pump using a selected or adjusted speed. This LED is on when the pump is
Start button/LED:
3
running.
Press this button to stop the pump.
Stop button:
4
This green power LED is on when IntelliPro is powered up.
On LED:
5
This LED is on when an error condition occurs. This green LED will flash a certain number of
Alarm LED:
6
times indicating a specific error condition. For the alarm LED flash sequence, refer to "Alarm LED
Sequence," on page 27.
IntelliPro Installation and User's Guide
1
2
5
6
4
3
Press one of the speed buttons to select the desired
Advertisement
Table of Contents
