Crankshaft Group; Cylinder Block (Pulley End); Assembly Overview - Cylinder Block (Pulley End) - Skoda Karoq 2018 Workshop Manual

13 –

Crankshaft group

1

Cylinder block (pulley end)

⇒ "1.1 Assembly overview - cylinder block (pulley end)",
page 35
⇒ "1.2 Summary of components - sealing flange on the belt pulley
side", page 37
⇒ "1.3 Removing and installing V-ribbed belt", page 38
⇒ "1.4 Removing and installing tensioning pulley for V-ribbed
belt", page 39
⇒ "1.5 Removing and installing vibration damper", page 39
⇒ "1.6 Removing and installing bracket for auxiliary units",
page 40
⇒ "1.7 Removing and installing engine support", page 41
⇒ "1.8 Removing and installing the sealing flange on the belt pul‐
ley side", page 43
1.1

Assembly overview - cylinder block (pulley end)

1 - V-ribbed belt
❑ check for wear
❑ mark the direction of ro‐
tation with chalk or a felt-
tip pen before removing
❑ do not kink
❑ Routing of the ribbed V-
belt ⇒ page 38
❑ Removing and installing
⇒ "1.3 Removing and in‐
stalling V-ribbed belt",
page 38
❑ pay attention to the cor‐
rect position on the belt
pulley when installing it.
2 - Screw
❑ Replace after disas‐
sembly
❑ ⇒ ETKA - Electronic
catalogue of original
parts
❑ 10 Nm + 90°
3 - Vibration damper
❑ with V-ribbed belt pulley
❑ Installation position:
Bore in the vibration
damper must be posi‐
tioned above the eleva‐
tion on the crankshaft
toothed belt sprocket
❑ Removing and installing
⇒ "1.5 Removing and in‐
stalling vibration damp‐
er", page 39
1.6/85; 2.0/110; 130; 140 kW TDI CR engine - Edition 06.2017
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Karoq 2018 ➤ , Kodiaq 2017 ➤
1. Cylinder block (pulley end)
35