Skoda Karoq 2018 Workshop Manual page 403

Vehicles with no clamping sleeve
– Cut the exhaust pipe at a right angle along the split cut
⇒ "1.3 Separating exhaust pipes/silencers", page 391
CAUTION
Risk of accident from weight of the rear silencer.
♦ A second mechanic is required to remove the rear silencer.
– Release screw left and right arrow -1-.
Note
Ignore -arrow-.
– Remove silencer -2-.
Vehicles with clamping sleeve
– Loosen the clamping sleeve -arrow- and slide it backwards.
CAUTION
Risk of accident from weight of the rear silencer.
♦ A second mechanic is required to remove the rear silencer.
– Release screw left and right arrow -1-.
– Remove silencer -2-.
Installing
Installation is performed in the reverse order, while paying atten‐
tion to the following:
– Align exhaust system free of stress
⇒ "1.6 Align exhaust system free of stress", page 396
Specified torques
♦ ⇒ "1.1 Assembly overview - silencers", page 381
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Underfloor trim
panel; Installation location overview - underfloor trim panels
1.5.3 Removing and installing fuel tank, vehi‐
cles with four-wheel drive, Karoq
Special tools and workshop equipment required
♦ Engine and gearbox jack , e.g. -V.A.G 1383A- or -VAS 6931-
1.6/85; 2.0/110; 130; 140 kW TDI CR engine - Edition 06.2017
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Karoq 2018 ➤ , Kodiaq 2017 ➤
.
.
1. Exhaust pipes/silencers
395