– Remove centre left underfloor trim panel ⇒ General body re‐
pairs, exterior; Rep. gr. 66 ; Underfloor trim panel; Removing
and installing underfloor trim panels .
– Take the electrical plug connection -arrow- for lambda probe
1 after catalytic converter - GX7- out of its bracket, unlock and
disconnect.
– Expose electric cable.
Vehicles with four-wheel drive
– Remove pre-exhaust pipe
⇒ "1.2 Removing and installing pre-exhaust pipe",
page 390
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
1.6/85; 2.0/110; 130; 140 kW TDI CR engine - Edition 06.2017
Karoq 2018 ➤ , Kodiaq 2017 ➤
9. Lambda probe
379